Fits Detroit Diesel Series 60 Front & Rear Wear Seal Sleeve Installer J-35686-B

Description

Store category
Sign Up Now !
You may also like
Fits Detroit Diesel Series 60 Front & Rear Wear Seal Sleeve Installer J-35686-B
Product Description
100%Brand New！！！
Free Shipping From USA
one year warranty!!！
High quality and high service
！！！
Fits Detroit Diesel Series 60 Front & Rear Wear Seal Sleeve Installer J-35686-B
Include:
1 x J-35686-B Seal and Wear Sleeve Installer. Supercedes J-35686-A
Description
:
QUALITY: Heavy duty J-35686-B Seal & Wear Sleeve Installer for Detroit. Manufactured from quality steel, using top of the line machining and measuring equipment to ensure each part is manufactured to OEM specifications.
ADVANTAGE: This tool is easier to use due to a simpler design. Protect your engine by preventing wear sleeve lip flare by using our low-priced but Quality installation tools.
BENEFITS: This tool set installs the front and rear crankshaft wear sleeves and seals. It eliminates lip flare on the wear sleeve and installs the seal properly. Prevent seal leakage.
Fits:
For use on Detroit Diesel Series 60 and two cycle 92.
Use on seal # 23516969 23513578 23513485 23518355
Works on Detroit Diesel Series 60, two cycle 92 engines. Used to install multiple Seal & Wear Sleeve Assemblies including 23516969 23513578 23513485 23518355
Instruction:
1. Lubricate the rubber outer diameter of the oil seal with clean engine oil. Lubricate the gear case cover or flywheel housing bore with clean engine oil.
2. Install two guide studs (J–35686–2) through the holes provided in the center guide assembly (J–35686–1) and into two of the tapped holes in the crankshaft 180 degrees apart. Tighten the guide studs. The base must be tight against the end of the crankshaft.
3. Install the spacers to the center screw of the base.
4. Slide the oil seal assembly over the installer base as far onto the crankshaft hub as possible. Slide collar with the stepped side contacting the seal. Slide the installer cup over the guide studs and installer base.
5. Lubricate the center screw of the base with extreme pressure lubricant. Install the thrust bearing with the case side toward the installer cup and install the hex nut to the center screw of the base.
6. Tighten the hex nut until the oil seal and wear sleeve are pressed into the flywheel housing or gear case cover.
7. When the inside surface of the housing is seated firmly against the base and spacers the seal and sleeve are properly installed. Remove tools.
Payment
About return policy
Warranty
WARNING
Contact us
Payment
We only accept PayPal and you can pay with your major credit card using PayPal.
PayPal is the safest and most secure way for buyers and sellers to sell online and that is why we use it.
About return policy
You must contact us before you return any item,we will deal with it immediately.
Warranty
This item have 1-year warranty.
In the event the item should fail due to manufacturing defects during intended use, we will replace the part by free.
We only warranty cost of item parts. Any installation or other fees are non-refundable.
If you have any problems, please feel free to contact us anytime.
WARNING
This product can expose you to chemicals including Chromium (Hexavalent Compounds),
which is known to the State of California to cause cancer, and birth defects or other reproductive harm.
For more information, go to California goverment website, you can search California P65Warnings.
Contact us
If you are interested in any of our products or would like to discuss a custom order,please feel free to contact us.
All emails will be answered within 24 hours.All the problems will be solved immediately .